How to design a print-in-place hinge
How print-in-place hinges work, which gap to use, how to orient them, and how to fix a hinge that comes off the printer stuck.
A print-in-place hinge comes off the printer already assembled and working: two leaves joined by a barrel, with the pin printed inside the knuckles of the other leaf. No screws, no glue, no assembly.
How it works
The barrel is split into knuckles that alternate between the two leaves — leaf A, leaf B, leaf A… The pin belongs to leaf A and runs through the knuckles of leaf B. Between every pair of parts there is a small gap, so the slicer prints them as separate pieces that can turn.
The numbers that matter
- Gap: 0.3–0.5 mm. Start with 0.4 mm. Too small and the parts fuse; too big and the hinge wobbles.
- Knuckles: an odd number (3, 5, 7) so both outer knuckles belong to the same leaf and hold the pin.
- Barrel diameter: at least 5–6 mm for small hinges. The pin needs about 2.5 mm or more to be strong.
- Leaf thickness: 2–3 mm. Thicker than the barrel radius doesn't help.
Printing it
- Print it flat, exactly as designed — the barrel axis horizontal and the leaves on the plate.
- Don't use a brim around the barrel, and keep elephant's foot small (it can glue the knuckles together at the bottom).
- After printing, bend it firmly once or twice. Tiny strings between the parts break and it moves freely.
If it's stuck
- Increase the gap by 0.1 mm and print again.
- Check the first layer: if it's squished wide, the knuckles may be fused at the bottom. Lower the first-layer flow or add a small chamfer.
- Print a little slower and cooler — less sag means fewer fused spots.
The fastest way to try it: the print-in-place hinge generator. In the FabMake editor you find the same hinge in the Parts library, ready to combine with your own design.
Free, in your browser, made for 3D printing — threads, fits, hinges and print checks built in.
Open the editor