FabMake

Threads in 3D prints: printed threads, inserts or self-tapping screws?

When to print a thread, when to use a heat-set insert and when to let the screw cut its own thread — with hole sizes, clearances and print settings.

2 min read

There are three ways to put a screw thread into a 3D-printed part. Picking the right one saves a lot of frustration.

1. Print the thread

Best for big threads: jar lids, knobs, bottle caps, M8 and larger bolts.

  • With a 0.4 mm nozzle, threads from about M8 upward print well. Smaller ones lose their shape.
  • Give the internal thread (the nut) extra room: 0.2–0.3 mm per side. FabMake does this automatically when a threaded hole is set to the Slide fit.
  • Print bolts standing up and nuts flat, so the thread is built from layers stacked along its axis.
  • Use thinner layers (0.12–0.16 mm) for smoother threads.
  • For lids, use a coarser jar thread and 2–4 starts so it closes in fewer turns.

In FabMake: select a cylinder → Thread, or select two parts → Screw them together.

2. Heat-set inserts

Best for small metal screws (M2–M5) that will be opened and closed many times. A brass insert is melted into a slightly smaller hole with a soldering iron and gives you a real metal thread. See heat-set inserts.

3. Let the screw cut its own thread

Best for quick, permanent assemblies. Make a plain hole a bit smaller than the screw and drive the screw in — it cuts its own thread into the plastic.

Screw Hole for self-tapping Clearance hole (screw passes through)
M2 1.6–1.8 mm 2.4 mm
M2.5 2.1–2.2 mm 2.9 mm
M3 2.5–2.7 mm 3.4 mm
M4 3.4–3.6 mm 4.5 mm
M5 4.3–4.5 mm 5.5 mm

This doesn't survive being unscrewed many times — use an insert for that.

Try printed threads with the free bolt and nut generator.

Design it in FabMake

Free, in your browser, made for 3D printing — threads, fits, hinges and print checks built in.

Open the editor